RG-T070QWE-01PD — 7.0″ 800x480 TN TFT LCD Module

Panel, resolution and form factor

The panel uses TN; the native resolution is 800x480.

Active area 154.08x85.92 mm sits inside an outline of 164.90x100.00x7.20 mm — the difference is the bezel, driver area and connector allowance your mechanical drawing must reserve.

Backlight brightness and viewing conditions

Typical luminance is 250 cd/m². At this level the module is suited to indoor, enclosed or low-glare environments — indoor office lighting, control cabinets, or products inside a housing. For daylight-readable or outdoor use you would need a high-brightness variant or a transflective / sunlight-readable panel instead.

MCU interface and display driver IC

The module is driven over RGB 24bit 50PIN Short FPC. This is the electrical interface between your MCU and the panel, and it determines two things: how many pins and how much board area your PCB needs, and how fast the screen can be refreshed.

A parallel RGB interface needs more pins and trace count but delivers high throughput, which is appropriate when you need fast frame updates or video.

Display driver IC: EK9713CA. Knowing the driver lets your firmware team pull the correct initialisation sequence and timing parameters — this is the usual starting point when bringing up a new panel.

Touch capability

This configuration includes resistive touch. It works with any finger, glove or stylus and responds to pressure rather than capacitance, so it suits environments where gloves are required or where the panel may be behind a thick protective window. Multi-touch and wet-finger behaviour are limited compared with capacitive.

Environmental range and storage

Operating temperature is -20 °C to 70 °C — the panel must be within this range during operation. Specify enclosure ventilation and consider thermal rise from electronics inside the housing, because internal temperature can exceed ambient.

Storage range is -30 °C to 80 °C, which matters for shipping, warehousing and unpowered periods — particularly relevant for products shipped through hot climates or stored in containers.

Integration and ordering notes

Every model in this series is held in permanent stock with MOQ 0, so samples and production quantities ship from the same bin and the specification does not change between them. Stock items typically ship within 24–48 hours.

If your project needs something the standard configuration does not cover — a different interface, touch type, brightness range, backlight life or outline dimension — it is worth asking for a custom quotation. Adjusting an interface or outline within an existing family is usually far cheaper and faster than starting a new module from scratch, and the factory-direct route means you deal with the manufacturer rather than a trading company.