RG-T101HIEWA-01CP — 10.1″ 1280x800 IPS TFT LCD Module

Panel, resolution and form factor

The panel uses IPS; the native resolution is 1280x800.

Active area 216.96x135.60 mm sits inside an outline of 260.00x170.00x6.95 mm — the difference is the bezel, driver area and connector allowance your mechanical drawing must reserve.

Backlight brightness and viewing conditions

Typical luminance is 850 cd/m², which is high enough for high-ambient-light use — outdoor kiosks, vehicle-mounted equipment and industrial panels in direct light. Note that rated luminance is measured under specified test conditions; in direct sun, cover glass anti-reflective coating and enclosure venting still influence the perceived brightness.

The panel is IPS, which keeps colours and viewing angles stable when viewed off-axis — useful where the screen is not directly facing the user, such as angled panels, handheld instruments or equipment mounted at a slight tilt.

MCU interface and display driver IC

The module is driven over LVDS 6/8bit 40PIN. This is the electrical interface between your MCU and the panel, and it determines two things: how many pins and how much board area your PCB needs, and how fast the screen can be refreshed.

LVDS carries high-volume pixel data over a differential pair, which gives high bandwidth over long cables and strong noise immunity. It suits larger panels and higher refresh rates, and requires a matching LVDS input on your host processor.

Display driver IC: EK79202. Knowing the driver lets your firmware team pull the correct initialisation sequence and timing parameters — this is the usual starting point when bringing up a new panel.

Touch capability

This configuration includes capacitive touch. It reacts to a conductive finger or stylus behind a cover lens, supports multi-point gestures in most configurations, and needs no pressure. Expect to design a cover lens with a suitable thickness and to include touch firmware from the controller vendor.

Environmental range and storage

Operating temperature is -30 °C to 85 °C — the panel must be within this range during operation. Specify enclosure ventilation and consider thermal rise from electronics inside the housing, because internal temperature can exceed ambient.

Storage range is -30 °C to 85 °C, which matters for shipping, warehousing and unpowered periods — particularly relevant for products shipped through hot climates or stored in containers.

Integration and ordering notes

Every model in this series is held in permanent stock with MOQ 0, so samples and production quantities ship from the same bin and the specification does not change between them. Stock items typically ship within 24–48 hours.

If your project needs something the standard configuration does not cover — a different interface, touch type, brightness range, backlight life or outline dimension — it is worth asking for a custom quotation. Adjusting an interface or outline within an existing family is usually far cheaper and faster than starting a new module from scratch, and the factory-direct route means you deal with the manufacturer rather than a trading company.