Custom Service

Custom Cable & Connector Solutions for TFT Modules

The connection from panel to host is where many integration projects stall on a mismatched connector or a tail that will not route. Custom cable and connector work covers the FPC tail itself — length, shape, connector and pinout — and the adapter or harness that bridges any gap to your host. This page covers what is customisable and when a converter board is also needed.

What Can Be Customised

OptionWhat it does
FPC tailLength, shape and routing to fit your enclosure
Connector & pinoutMatch your host end directly
Adapter / harnessPassive bridge for connector or pinout mismatch
Conversion boardInterface translation where host and panel differ

Passive vs Active

If the host and panel speak the same native interface but the connector or pinout differs, a passive adapter or harness is enough — no firmware, no init code. If the interface itself differs (an RGB host driving an LVDS panel, for example), a converter board is needed; that is a separate guide. The rule: change the connector with a cable, change the language with a board.

Send the Mechanical Drawing

The FPC can be reshaped within the panel's mechanical limits to route into your layout. Send the enclosure mechanical drawing (or a sketch of the route) and we will propose the FPC form and the connector that mates with your host.

Matching Standard Panels

Cable and connector customisation applies across the catalog. These standard modules are frequent subjects:

Related Guides

Frequently Asked Questions

What can be customised on the cable side?

The FPC tail length and shape, the connector type and pinout at the host end, and the provision of an adapter or conversion board where the host interface differs from the panel's native one.

Do I need a board if only the cable differs?

If the host speaks the panel's native interface but the connector or pinout differs, a passive adapter or harness is enough — no firmware. If the interface itself differs (e.g. RGB host, LVDS panel), a converter board is needed; see our adapter-board guide.

Can the FPC be reshaped to fit my enclosure?

Within the panel's mechanical limits, yes — the tail can be re-routed or re-shaped so it mates with your layout. Send the enclosure mechanical drawing and we will propose the FPC form.

Talk to Our Engineers

Send your host connector, pinout and enclosure drawing to sales@odmlcd.com — we will reply with an FPC and adapter proposal for your module.

Drawing Handoff Checklist

A custom cable lives or dies on the drawing. Include the connector model, pinout, wire gauge, bend radius, and the strain-relief length at each end. Photographs of the mating connectors catch mismatches that a netlist alone hides.

Passive vs active

Keep the cable passive where the signal allows; move to an active or repeater solution only when length or noise forces it, since active parts add points of failure. Validate the first article against the actual host, not just a continuity test.

First-article check

On the first sample, seat both ends on the real hardware and confirm every signal under load, not just at the bench. A cable that passes continuity but drops a line at temperature is the failure you catch now or in the field.